Instructions

Data Elements: ucInstruction.aspx

No Sweep™ Digital C/C Gauge with AccuLevel™ ver. 2

Operating Instructions

This gauge can only be used on large diameter tubular spindles - both “Wide 5” and “5-on-5”. An indexing adaptor is required to go inside the spindle (sold separately - see adapter instructions for installation).

1) Find a level place to set up your front end. This unit reads camber very accurately. Unlevel ground will affect the accuracy.
IMPORTANT: BE SURE WHEELS ARE POINTED STRAIGHT AHEAD WHEN SETTING CASTER AND CAMBER.

2) Attach the gauge to the spindle - the black gauge adapter screws onto the spindle snout. A narrow bar on the inside face of the gauge adapter indexes with a groove in the face of the spindle adapter. Hand tighten the gauge adapter.

3) To measure caster and camber slide the AccuLevel™ into the groove of the gauge body as shown below for each. Read the caster and camber directly (no need to turn the wheels to read caster).

4) Adjust the caster and camber as needed. Each time you make a change bounce on the front end to settle the suspension. NOTE: Adjusting the caster may have an effect on the camber and vice versa. Double check all settings & tighten bolts.

See the separate instructions for the AccuLevel™ if needed. It can be removed and used for other measurements. Simply slide the AccuLevel™ out of the groove.

No sweep camber

 

No sweep caster

Related Products