Pairing the Pyrometer with the Tablet
The pyrometer probe and tablet are connected wirelessly via Bluetooth®. Occasionally the pairing between the two could be lost and you will need to re-pair them. This is a very simple process that takes less than a minute.
PREPARE: Close the Memory Tire Pyrometer app (if open).
START: Tap the Settings icon to get to the settings page, tap Connections at the very top left, then tap the Bluetooth® icon (be sure Bluetooth® is on –slide green bar to the right ) .
At the upper right in MY DEVICE tap the empty box on the right. This temporarily allows connection to unpaired devices – your pyrometer. You have 2 minutes to complete the pairing process (plenty of time). See the countdown timer. If you do not get the pyrometer paired in this time you will need to start over.
Once you tap this box and the timer has started, press and HOLD the Pyrometer READ button. The LED will turn red. At this point release the READ button and momentarily push it again. The LED will go out, and then come back on steady green. In a few seconds the tablet will ‘whistle’ and a message will come up “DO YOU WANT TO PAIR WITH THIS DEVICE?” Tap OK. Now open the Memory Tire Pyrometer app. Within 5-10 seconds the connection will be made and the active temp should display.
If it still does not function – display active temp – your security system ID (SysID) may have been corrupted. See Enter SysID section on page 13 and re-enter it. This is very quick and simple.